What pressure should I expect with a Diamond Hydride 2.o HPLC column at flow rates from 0.2 to 2.0mL / min - FAQ
October 14, 2015
/
/
/
/
/
/
The below data was recorded on a Waters UPLC™ system.

Please note that the pressure can vary widely depending on such factors as mobile phase viscosity, temperature, column ID, and column length. The conditions shown below should clarify any questions you may have regarding this data.



Column: Cogent Diamond Hydride™, 2.2um 120A, 2.1 x 50mm, cat# 70200-05P-2
Flow Rate: 0.2-2.0 mL / minute
Temperature: 25°C, thermostatted
Mobile Phase: 80% Acetonitrile / 20% DI water / 0.1% formic acid, premixed (v/v)



Cogent Diamond Hydride Product Page

Related Articles

  1. Common cause of excessive back pressure in HPLC columns - FAQ
  2. How do retention and efficiency of asymmetric dimethylarginine ADMA compare using 4um vs 2.o Diamond Hydride columns - AppNote
  3. What is the maximum pressure Cogent HPLC columns can tolerate - FAQ

© Copyright 2025. MICROSOLV. All Rights Reserved. Website & Hosting by BlueTone Media